Galintel® Multi-Rib T-Bars are cost effective lintels that provide structural rigidity, high strength-to-weight ratio and resistance to corrosion. The multi-ribbed profile forms a superior bond with the mortar. This bond between mortar, brickwork and lintel creates a composite beam of superior strength and structural integrity. The Galintel® Multi-Rib T-Bar is a total load bearing lintel designed to support 230mm brickwork over a clear opening. Installation Place Galintel® Multi-Rib T-Bar in position on brick piers, with minimum end bearing of 150mm. Prop before bricklaying. Props must be no further than 1.2 metres apart and must remain in place until mortar has fully cured. Apply mortar (minimum 1:4) to all brick faces in contact with the T-Bar. The same number of courses must be laid internally and externally to prevent twisting of the T-Bar. Composite Action Galintel® products rely on composite action. Therefore, to achieve ultimate performance, mortar must be present at all contact surfaces between bricks and lintel. Control Joints Where control joints are used as a required structural element, loading of the lintel should be reduced by one third .

All GALINTEL® steel lintels are manufactured to comply with Australian Standards, containing certain markings for clear identification post-install. For added peace of mind, all GALINTEL® products are made with high quality steel and backed by a25 year warranty^.